The ‘Two-Pin’ technique increases sanitation for multiple dose vial users. They draw with the first pin, and then shoot/inject into the body with a new one. This procedure prevents any residual contaminants that may have remained on the drawing pin from being transferred into the body via the injection site. It also makes injection less painful since the drawing needle is necessarily dulled during passage through the rubber stopper atop the vial. A dulled needle increases injection pain because it doesn’t pierce the body as cleanly as an unused one. The protocol below is followed by AAS users who draw from multiple dose vials, but steps 4 - 8 are routinely disregarded by those users who draw from ampoules (also called ampules) and sachets.
With the numerous points we have to choose from for our steroid injections most will find the glutes and lateral (side) deltoid head to be the most comfortable and convenient points of administration. Injection sites such as calves and traps are highly warned against; although in terms of adequate injection sites they are fine, they can produce a fair amount of pain in the individual. No matter where you choose to inject always practice sanitary methods; do not reuse needles or syringes, clean the area thoroughly before injection and always sterilize with alcohol beforehand.
How often cortisone injections are given varies based on the reason for the injection. This is determined on a case-by-case basis by the health care practitioner. If a single cortisone injection is curative, then further injections are unnecessary. Sometimes, a series of injections might be necessary; for example, cortisone injections for a trigger finger may be given every three weeks, to a maximum of three times in one affected finger. In other instances, such as knee osteoarthritis, a second cortisone injection may be given approximately three months after the first injection, but the injections are not generally continued on a regular basis.